- Liittynyt
- 25.1.2007
- Viestejä
- 3 123
United States All-Round Weightlifting Association liitosta oltiin juuri muhun yhteydessä. Laitoin ton mun 170kilon nostovideon heille malliksi ja kysyin onko sääntöjen mukainen nosto ja onnistuuko Reeves Deadlift kisojen pito David Hornen Winterfest tapahtuman yhteydessä. Vastaus oli lyhyt mutta ytimekäs:
"That is a VERY GOOD lift!!!! Just how the Reeves Lift should be done. Great job. I've seen lots of Reeves lifts where a shorter bar is used, or plates with handholds that are in them - and that is not how Steve Reeves did it. I'll be looking forward to seeing how this competition goes."
Joten jos kiinnostusta löytyy niin olkaahan muhun yhteydessä. Tehdään hieno kisa ja kovat tulokset niin taas saadaan Suomea maailmankartalle.
Grip Monsters :: Winterfest 2013
Reeves Deadlift 374.79lbs - YouTube
GripMonster(at)sci.fi
USAWA Rule for the Reeves Deadlift:
“The rules of the Deadlift apply with these exceptions. The lift starts by the lifter gripping one plate on each side of the bar. The flanges of the plates may be turned outwards to provide a better gripping surface. A regulation bar of legal length must be used. There are no width specifications of the flanges of the lifting plates. Weight is added to the bar with smaller diameter plates so the lifter always has just one plate per side to grip.”
"That is a VERY GOOD lift!!!! Just how the Reeves Lift should be done. Great job. I've seen lots of Reeves lifts where a shorter bar is used, or plates with handholds that are in them - and that is not how Steve Reeves did it. I'll be looking forward to seeing how this competition goes."
Joten jos kiinnostusta löytyy niin olkaahan muhun yhteydessä. Tehdään hieno kisa ja kovat tulokset niin taas saadaan Suomea maailmankartalle.
Grip Monsters :: Winterfest 2013
Reeves Deadlift 374.79lbs - YouTube
GripMonster(at)sci.fi
USAWA Rule for the Reeves Deadlift:
“The rules of the Deadlift apply with these exceptions. The lift starts by the lifter gripping one plate on each side of the bar. The flanges of the plates may be turned outwards to provide a better gripping surface. A regulation bar of legal length must be used. There are no width specifications of the flanges of the lifting plates. Weight is added to the bar with smaller diameter plates so the lifter always has just one plate per side to grip.”